Skip to content
MAGDA Manual

Strum

Strum is a MIDI device that turns a held chord into a strum, a roll or a quick arpeggio. Instead of every note starting at once, the notes start one after another, spaced along a curve you choose.

Overview

Strum sits on a track's device chain before an instrument, like the Arpeggiator. It works with any instrument, MAGDA's own or a plugin. Play a chord and Strum sends its notes on in the chosen order, spread over the Strum Length. The notes keep the velocities you played.

The panel beside the parameters shows where each strummed note lands in time for the current Shape and Cycles. It previews the timing, not a particular chord.

Triggering

Trigger sets when a strum happens:

  • Chord strums once each time you play a chord. Strum waits a moment after the first note so the whole chord is caught, and strums again if you add a note. The notes ring until you release the chord.
  • Loop strums the held chord over and over until you release it. Each new strum ends the notes of the one before.

In Loop mode, Loop Sync sets how the gap between strums is measured: Time uses Sync Interval in milliseconds, and Beat uses Loop Rate, a note value that follows the project tempo.

Parameters

Parameter Range Default Description
Trigger Chord, Loop Chord Strum once per chord, or repeatedly while it's held
Order Up, Down, Up/Down, As Played Up The order the notes start in. Up goes from the lowest note, Down from the highest, Up/Down goes up then back down, and As Played follows the order you pressed the keys.
Shape Linear, Ease In, Ease Out, Snap, Spike, S-Curve, Overshoot, Bounce Ease In The curve that spaces the notes across the strum
Cycles 1–8 1 Splits the strum into that many short strums, each following the shape
Strum Length 1–400 ms 90 ms Time from the first note to the last
Loop Sync Time, Beat Time In Loop mode, measure the gap between strums in milliseconds or note values
Loop Rate 1/1, 1/2, 1/4, 1/4T, 1/8, 1/8T, 1/16, 1/16T 1/4 Gap between strums with Loop Sync set to Beat
Sync Interval 60–2000 ms 500 ms Gap between strums with Loop Sync set to Time

Macros, modulation, and presets

Strum sits in the standard device slot, so its parameters accept macros and modulators, and its settings save and recall through the preset system.